G-Force Nova GFNQ8000 QL80 Shank

Features:

• No foot valve required
• Easy to service
• Special heat-treated alloy piston for long life, Rockwell hardness 60
• Minimum loss of performance when injecting foam or water

Specifications

Length (w/o drill bit)	56.1"
Outside Diameter	7.28"
Weight (w/o bit)	441 lbs.
Cylinder Bore	5.925"
Piston O.D.	5.92"
Piston Stroke	2.38"
Piston Weight	92.9 lbs.
Hole Sizes	7 7/8" - 10"
Air Pressure Consumption	150 psi - 350 psi
Wrench Size	A/F 5.512"
Connection	Std. 4 1/2" API Reg Pin

Air Consumption Chart

PSI	150	200	250	300	350	400
CFM with blank choke	445	650	850	1,045	1,240	-
with 1/8" choke	-	-	-	-	-	-
with 1/4" choke	-	-	-	-	-	-

All Hammers come Fitted with blank Choke located in the Air Check Valve

Hammer Service Log

Wear Sleeve / Piston Clearance

Part	New Dimension		Discard Clearance
Wear Sleeve	A	5.93"	greater than or equal to 0.010"
Piston OD	B	5.92"

Inner Cylinder / Piston Clearance

Part	New Dimension		Discard Clearance
Cylinder ID	C	5.39"	greater than or equal to 0.010"
Piston OD	D	5.38"

Distributor Probe / Piston ID Clearance

Part	New Dimension		Discard Clearance
Distributor Probe OD	F	1.84"	greater than or equal to 0.010"
Piston ID	E	1.85"

Bearing - Piston OD Clearance

Part	New Dimension		Discard Clearance
Bearing ID	H	3.19"	greater than or equal to 0.010"
Piston OD	G	3.18"

External Wear

Description	Wear Limit
Wear Sleeve Reverse Dimension	6.93"
Wear Sleeve Discard Dimension	6.85"
NOTE: Chuck should be replaced when wear transfers to wear sleeve.

Lubrication

G-Force Series Hammers are precision-made tools and should be treated as such. Only the highest quality lubrication should be used and a constant flow of oil must be maintained at all times. Recommended lubrication amount 1/3 Pint per 100 cfm per hour.

Recommended Grades of Lubricant

ESSO MATEX CASTROL SHELL MOBILE

AROX EP 150 RDO 302 RD OIL DP 100 AIR TOOL OIL 2 A 320 ALMO NO. 5

Heavy duty oil is recommended for all year-round use, in particular where air supply to the hammer is at high temperature. If lighter grade oil is required due to very low ambient temperatures, amount of oil being used should be increased by 30 percent.

Recommended Pull Down

Minimum @ 100 psi - 2500 lbs.

Maximum @ 350 psi - 6500 lbs.

---

Missile Warranty will be voided by the following:

Welding on Wear Sleeve.
Heating Case with a Torch.
Gripping Wrenches across Threads.
Hammering on Casing.

READ WARNING LABEL ATTACHED TO HAMMER.